Providing these water quality things are fine there is the chance that the cord running to the disposal has developed a short or a wire has become disconnected. You will need to disassemble the unit to verify all wires remain securely fastened. The last conclusion is that the motor has burned out, in which case you will need to replace the disposal unit.
The repair of a ballcock tube is the simplest repair of all toilet leaks. There is a small black tube that is in the tank of the toilet that connects to the flush valve fill tube. If the tube slips from the little clasp that holds it in place, it can begin spraying water line repair in the tank and out from under the tank cover. To fix this toilet leak, simple re-attach the black tube to the clip. It really is that simple.
If you need to add copper pipe make sure that you clean the old and new pipe by using sandpaper, inside and out. If it's not clean the solder will not flow into the joint. Another tip is to not over wrap the mail threaded pipe with tape, this can cause a leak. Twice around should be enough. Also, don't over tighten it.
Clean the hole in the gutter railing first. It must be free of any debris, so you may want to clean the entire drain channel using a proper cleaner. In this way, you will have a clean surface area which will allow you to repair the hole more easily.
Check that your plug holes and waste outlets are clear of hair and solidified soap also check the "U" bends or traps under your sinks for potential blockages. Occasionally pour boiling water line repair down your sinks and shower wastes not forgetting the washing machine trap. Look outside too for any weeds or leaves that may be blocking gutters, gully's and waste outlets.
For a newly installed icemaker, you will need up to 24 hours to let the machine function and cool down. A newly installed icemaker may not work until the ice mold temperature has dropped to about 15F - 16F degrees. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the machine to start working. Also, a newly installed water line may have air in the line. It can sometimes take a few ice making cycles to clear the line of air.
Once you've located the water shut off, turn it off. Now, you can turn your attention to trying to contain the water damage caused by any leaking. Get towels, fans, blankets, or anything else to try and sop up water that is sitting on carpet or wood floors. Linoleum floors usually don't undergo much damage from having water sitting on them, unless there are cracks in the linoleum (often invisible) where the water can seep in. When your Queens plumber arrives, you will be one step ahead by following these instructions.